 Hull |
Scratch |
| Motor |
Graupner
480 7.2V Race |
| Speed
Control |
Castle
Creations 35A (May need to be modified for water cooling) |
| Cells |
8
X Nimh AA (Rayovac) |
| Hardware |
Octura
.098 Cable w/ 1/8 Stub Shaft. Home-Made strut and rudder |
| Prop |
X431
Plastic |
| Hull
Length |
15"(not
including hardware) |
| Hull
Width |
7
5/8" |
| Weight |
Target
1.5lbs RTR |
| Speed |
|
Special
Notes
Special Notes: Hull Materials: 1/8 Balsa and White Styrofoam
with 1/32 and 1/64 plywood sheeting. Will it Float? Yea, even if
I load it up with rocks. The hull can also be setup for 4-cell racing
and a hot 05 modified motor.
Trent, here are the pics for the Micro Aggressor. These are
the pre-build photos Things are still rubber-banded together. The
center tub is the protoype model I made for center of gravity and
general layout purposes only. The finished boat should be in the
20-24 oz range(depends on hardware and how fancy the finish will
be). The final tub version will be ply covered foam(in the front
and rear). Depending how fancy I get with the hardware and the layout,
the boat should begin testing in about 2 weeks. If everything works
well I'll post a build article with some more pictures in late November.
Thanks for your hard work on Microhydros.com! |
 |
 |
Eric
Perez