 Special
Notes
Here is my new boat. It is a mini cat from Hopf. It is powered
by Mega 16 / 7 /5 motor with speed control
MGM 1803PH. On test drive I used plastic prop K31. The cells were
SANYO 1200 2/3 SUB-C. Drive shaft is built of 1.2 mm steel wire.
It runs in a teflon tube. At the end of it, are two bearings. The
boat cast is hard in original, so I only strenghten back wall, which
carry rudder and driveshaft. This strength is built from 1.5mm epoxy
plate. The same material was ussed for motor supports.
Regards: Ales Zaloznik
Trzaska 214
Ljubljana Slovenia |
 |
 |
Ales
Zaloznik